Paul B
I dig hammocks.
ok, I have an Echo CS330 top handle, it runs fine when it gets going but it takes FOREVER to warm up. I used it today. 10 pulls to get it idling, then after about 3 minutes of idling at low RPM I touched the gas trigger and it bogged out and stalled promptly. After starting and doing the same thing about 10 times before it finally would spin the chain and rev out without stalling I got my job done.
I have never adjusted the settings of the saw, the air filter is clean and it was brand new mix gas (supreme 94 octane).
Any ideas on what I could do better (other than buying a new saw)?
I have never adjusted the settings of the saw, the air filter is clean and it was brand new mix gas (supreme 94 octane).
Any ideas on what I could do better (other than buying a new saw)?