The Official Work Pictures Thread

[SeanKroll]

I've wondered about jam protection.

I didn't feed it max sized chunks our of concern for jamming.

 

[Mick!]

I've wondered about jam protection.

I didn't feed it max sized chunks our of concern for jamming.

Don’t worry about maxing it out, you can do it all day (as I did today as a matter of fact) stress control will deal with it.

It can happen if you turn it off before it’s emptied the chamber, because the wheel stops quickly (direct drive) a small piece can drop between the anvil and the blade.
It can happen once a year or never, but I once took the dog for a walk leaving the men to chip up a birch and they tried to start it for fifteen minutes, next day the flywheel bearings collapsed.

 

[SeanKroll]

I've wondered about jam protection.


I am not concerned about chipping a max log, it's the odd, large chunk, especially by itself.

Maybe unfounded.

 

[CurSedVoyce]

Hell, that can happen on my 1250. Probably any chipper.
Always let it run a few to clear the throat and blades before shut down

 

[CurSedVoyce]

I'll even foward and reverse the feed a couple times in case something needs bumped looseto finish out

 

[flushcut]

Keep it wide open and hit it with a blower in the infeed chute.

 

[Mick!]

What is that?

Looks like a fox ‘stole’

 

[biggun]

What model was it again Sean?

230 or 280?

 

[Nutball]

A Vermeer 1000 will jam often enough. I haven't found the exact pattern as to why. The worst was when, due to it's stupid design, someone simultaneously throttled it up and disengaged the clutch, and somehow the feed wheels were still working, ramming a branch into the freewheeling drum. That was a mess to clear.

 

[SeanKroll]

What model was it again Sean?

230 or 280?

280

 

[SeanKroll]

I talked to another biz owner this morning. His BC900 is only 35 hp.

59 HP does a lot with hand feeding without autofeed engaging.
I'm only familiar with 25hp and 35hp rentals from a handful of occasions.

 

[davidwyby]

I ran a chipper for the first time the other day. Big old Vermeer. Kinda cool but I think I prefer fire. 😆

 

[biggun]

280

Should do you proud.

They are a very capable machine.

Congratulations.

 

[treesmith]

Fun time today. Got a call two weeks ago about an uprooted pine hung in another one. Fair size pine…over 90’ tall. I set a 5/8” Stable Braid line in it and ran it over the primary and anchored off with a 2:1 to the base of a large oak. Used the Ram to lift it enough that I knew it wasn’t resting in the other pine. Then went up and just started whittling away at it. Once I got down to my guy line, I dropped on down and set another one a bit lower, which I had to route between the primary and ground wire to the base of the same oak. Then went back up and blocked it down to the lower line. I eased off the tension and the root ball held it there so I was able to fell it without having to go up again.

 

[cory]

#skillz

 

[Burnham]

That's a challenging one, from the rigging to the climbing, to keeping your mind from messing with you over the whole shebang. Very good work.