ruel
TreeHouser
I've had an old 066 kicking around for a while not running. Last fall I put a new piston/ cylinder in it and got it to catch for a bit. After a min of running it sputtered out.
Replaced the air filter, spark plug, carb, intake boot and impulse line today, but it won't catch now. Can you saw folks give me a beginner idiots troubleshooting checklist?
Im frustrated cause it did start a few times, I set the carb adjustments to 1 turn out on all 3 needles, electrical thingy is set as close to the flywheel magnet as i could get it
Just trying to get a cheapo saw for milling, not needed for work, so I'm happy to keep tinkering
Replaced the air filter, spark plug, carb, intake boot and impulse line today, but it won't catch now. Can you saw folks give me a beginner idiots troubleshooting checklist?
Im frustrated cause it did start a few times, I set the carb adjustments to 1 turn out on all 3 needles, electrical thingy is set as close to the flywheel magnet as i could get it
Just trying to get a cheapo saw for milling, not needed for work, so I'm happy to keep tinkering