Raj you can use a heat gun or one of those little propane torches to get the bubbles out of the epoxy. I also built a board flattening jig. Recently bought a 2 1/4 hp porter-cable router and a 2 inch spoilboard bit. I built the gantry from plywood. Am building a table from some wood I got...
Congratulations Brian. Sounds like a great addition. We had three walnut sweepers that had the 31 hp Wisconsin motors in them. We had few problems with them. One was the breather getting plugged up with dirt and it then pushing oil into the magneto. I can't remember just why but we replaced...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.