Search results for query: *

Here is a test of a good woods ported saw !!! Looks like a Dolmar. Steve <iframe width="560" height="315" src="http://www.youtube.com/embed/g8-aFLiivHA" frameborder="0" allowfullscreen></iframe>

This here is just plain UGLY ! I like where he crosses his heart before climbing the ladder :lol: Steve <object width="640" height="385"><param name="movie" value="http://www.youtube.com/v/RUIGBS7B7WY?fs=1&hl=en_US"></param><param name="allowFullScreen" value="true"></param><param...

Well I have finally been reduced to chunkin' up the big blocks with the chainsaw in order to lift them onto the splitter :cry: Got to admit though the 2100cd is the right saw for the job !! Just put it together a short while back ,had to put a new clutch & a bunch of other little odds & ends...

Grabbed my (2) 038's,1 mag & 1 super, to take to the woodlot to get some cutting time on them after rebuild/port job. Do you think I could get those suckers started ? Just about wore my arm out :X:X. So I pulled the filters dribbled in a bit-o-mix and after a couple attempts they start.Ran...

Here's one for ya? You guys who are regulars arround here have seen me posting questions on the 038 Mag I am going to do , WHEN I get this done will it pull a 24" bar with ease ?? I'm thinking full skip(?) chain. 24" may be overkill but with the BIG 066 spikes I have on order it will LOOK...

I've got my "doner "026" apart and clean as a whistle now. Jug is off and needs new p&c ,lost a small piece off ex. side skirt (not to be found).When crank is spun by hand the bearings feel good.If I pop out the seals and flush the CC with diesel should this be ok ? I'll also be able to visually...

Well here I go ! I think my next project is going to get a "POP-UP" (piston that is :lol:). Could someone OR everyone post their procedure on doing a WOODS MODDED saw with a pop-up ? AND explain why you are doing each step and the potential gains with each operation. This 038 mag P&C is begging...

Got the next 038 super on one bench, an 026 tore down on another :D:D. When looking over the super I noticed the tank/handle assembly is plastic ! When did they switch over to resin ? Is there a way to determine the date of manufacture and country of origin by the serial #'s ?If so, does it...

Does anyone have knowledge of any lists of factory squish #'s ? Or the technical specs. they shoot for at production ? Or maybe someone has a working knowledge of them from their own experience. These #'s I'm sure aren't "carved in stone",but there must be an average (tolerance) for each saw...

Well success at last ! Thanks to Cut4fun, Al Smith and Woodworkingboy for there guidence in my first Woods Modded 038 super ! I fired up the BEAST this morning and I have to say I'm HOOKED. Put it together,took it out, pulled & pulled....nothing ? Pulled off the air filter,dribbled in a bit of...