Search results for query: *

Thank you for the detailed information Trains/Grant. 😃. I’m not sure why the high and low jet tuning is such a difficult concept for me. I’ve done the idles on a few saws just fine after a couple questions were answered here. I’ve yet to hear the 4 stroking but can detect faster and lesser revs...

The 9000rpm is in wood?!! I would have never figured that. All else ( drills, reciprocating saws, oscillating tools ) have no load speeds. Strange. So I’m supposed to read wot rpm with the bar buried?

Maybe idle is a little low. What is WOT an acronym for? I only revved it 3 times upon startup to get 11000 rpm. Never did it before. Just looking for numbers to compare cold to warm. I’m anal about warmup and cooldown procedures. Generally, I start the saw, rev once to back down the rpm’s...

I ended up with a Tiny Tach. All the recommendations were good but the Tiny was readily available and fairly inexpensive. I used it today on the 450 Rancher. Revved to 11000 upon startup and when warm was at 9000 and 2500 idle I believe. Right on the specs. I figured it would be a good idea to...

I actually have no idea if they have limited coils. Mostly because I don’t know what they are !

I’m looking for a tachometer and I’m confused. Most of the ones I see have wires that you have to wrap around the plug wire or require foil tape for use. All the videos I see show someone holding the tach close to the motor only. This is the type of want to purchase. What are you guys using?