Search results for query: *

According to the engine's dyno graph only 22-25hp at the engine's shaft, though they call it a 30hp. The power curve graph says 30hp @3600rpm, but I don't think governors kick in full throttle at very close to the governed rpm. Vermeer set it to 3200rpm, it grinds at 2600-2900 under load. Last...

I just measured it at around 75" on the widest part (root flare), still around 55" or so going the other way. What think you price wise? I already have an idea what I'd ask. I'll probably end up hauling off the excess grindings too.

Has anyone's rates gone up since stuff got so expensive over the past couple years? If I had the need and the resources, I'd like to build my own grinder. I feel like I could make a good one for a lot less than what they cost new. The one I was using wasn't that bad once it went into beast...

So, one stump would be more? What about a 45" flush cut oak stump? Good ground, been cut for a year or less. I had rented a grinder, not cheap, and had hoped to share the cost with neighbors + a little profit as they came asking when they saw me grinding my own stumps, but I ended up spending...

What's your hourly rate? What are some up to date prices and methods of estimating how much to charge?