Search results for query: *

Yeah, I know and thanks, it took a days work to clear my head, sometimes I am blind to the obvious.:)

Yup, you are spot on I just adjusted the low speed and it's running fine again. The HT lead had come lose at the condenser, not all the way out, but enough maybe. Anyway, you lot are excellent, thanks for all the great help. I have a muffler with the baffles taken out to put on this saw.:D

So, I changed the set up so I have just the one hard check so it's like your picture Al. Check, seal, cover. Started it up and it ran fast as I had the idle screwed in, shut it off and it kept running! Bastard! I thought, must be a ignition problem, checked the plug again and nothing, it...

Low speed is quarter turn out, high speed is 3/4 turns out.

OK this is the order...gasket metering diaphragm (on the carb) , diaphragm assem'y metering. Soft diaphragm fuel pump, gasket circuit plate, harder gasket. The boot is fine.

Screws are adjusted to factory settings, I am going to make a coffee then check the boot.

OK, metering lever height was maybe a little low but by the tiniest of margins, saw runs, throttles up but stays revving fast when throttle released, will eventually slow to tick over but will eventually stall. Al, do you mean I can discard the backer and just leave the soft rubber one? I am...

No problem Al, that's what I was thinking, the wrong order, I have changed the order but alas, no improvement. I will investigate further on these matters with a clear head. That, will take a while.

They were a little stiff and slightly stuck down which is why I changed them, before I did change them the saw would run fine but to start it you didn't need to choke it, if you did it would flood the engine. Now it is difficult to start, runs for a while then cuts out and it won't tick over, I...

I am having running problems with my Stihl 361, changed the diaphragms but still awful, anybody got the diagram including blow up of the Walbro 21-477 5.2?