Cut4fun
Redneck Chainsaw Repair
- Joined
- Nov 27, 2007
- Messages
- 2,635
Might be easier to just find a dead parts saw. Any out there for trade or sale?
Just a list of wants for another 372 project.
muffler heat shield
muffler gasket
plastic base under carb
air filter mount low type
air filter clip for low top filter
muffler bolts
blue coil wire
air dam duct jet behind flywheel
oil pump drive worm gear type 1
complete oil pump set up
plastic black cover between recoil and flywheel
choke rod
oil pick up and tube
metal bar plate
hand guard brake handle
could always use better clutch cover and plastics.
Probably forgot some stuff but should get me close. Thanks.
Just piddling here and there with this 372 project.
Like new piston and cylinder with crosshatch and witness lines still. Like new crankshaft etc. I just hope it runs as good as the last 372 50mm I did.
Just a list of wants for another 372 project.
muffler heat shield
muffler gasket
plastic base under carb
air filter mount low type
air filter clip for low top filter
muffler bolts
blue coil wire
air dam duct jet behind flywheel
oil pump drive worm gear type 1
complete oil pump set up
plastic black cover between recoil and flywheel
choke rod
oil pick up and tube
metal bar plate
hand guard brake handle
could always use better clutch cover and plastics.
Probably forgot some stuff but should get me close. Thanks.
Just piddling here and there with this 372 project.
Like new piston and cylinder with crosshatch and witness lines still. Like new crankshaft etc. I just hope it runs as good as the last 372 50mm I did.
