Page 802 of 802 FirstFirst ... 302702752792800801802
Results 8,011 to 8,013 of 8013

Thread: O.C.G.D. Thread, part two

  1. #8011
    General Purpose Sponsor Stumpshot's Avatar
    Join Date
    Jun 2018
    Location
    Kansas City
    Posts
    1,263

    Default

    Or a table saw if you want perfectly parallel edges, and a consistent uniform end product. You could set the width of the fence to your chosen wedge, then just rip the cutting board down to the proper width. I've ripped cutting boards down before for restaurant equipment. The HDPE cutting boards can be processed with standard woodworking equipment -- sanders for round-overs on the edges, routers for edge chamfer, etc.

  2. #8012
    TreeHouser Sponsor
    Join Date
    Apr 2011
    Location
    France
    Age
    56
    Posts
    1,388

    Default

    Problem, the HDPE is very slippery and you don't want that to keep a pile column stacked with hard side hits. One plate should be fine but I can't see 2 or more stacked and staying as is while you beat the wedges over them.

  3. #8013
    Patron saint of bore-cutters Sponsor stig's Avatar
    Join Date
    Aug 2007
    Location
    Denmark
    Age
    61
    Posts
    17,425

    Default

    The extruded nylon that we use for stacking plates is very slick, too.
    Never had one slip while besting on the wedges.
    Deyr fÚ,
    deyja frŠndr,
    deyr sjalfr it sama,
    ek veit einn,
    at aldrei deyr:
    dˇmr um dau­an hvern.