Vermeer 1250

  • Thread starter Jonseredbred
  • Start date
  • Replies 9
  • Views 3K
J

Jonseredbred

Guest
Vermeer 1250a Brush Chipper.
300 CI Ford 6 cyl. engine. Lots of power and easy on fuel, 12 gallons per day heavy chipping.

Sandblast, epoxy prime and paint, new tires, new chip chute 2 years ago.

Feed wheel bearings and assembly rebuilt less than 300 hours ago.
It has had new disc bearings, waterpump, radiator, fan and cutter bar this summer.

It has had 2 new hydraulic feed motors this past month($1,000.00), new knives and a new set of chipper belts are included.

Not perfect but a good used ready to run tow behind chipper.
 

Attachments

  • 0911091043a.jpg
    0911091043a.jpg
    157.4 KB · Views: 184
  • 0911091042a.jpg
    0911091042a.jpg
    39.1 KB · Views: 181
  • 0911091044a.jpg
    0911091044a.jpg
    140.7 KB · Views: 196
  • 0911091045a.jpg
    0911091045a.jpg
    110.4 KB · Views: 190
What's the diameter capacity and is this presented as "Sell", "Trade", or "Give It Away"? Nice looking rig. I need a newer chipper...
 
Morbark 290...OLD Morbark 290. It runs okay...uses some oil...it makes me nervous to use it. I just know sometihing else is gonna tear up. I haven't used it in about a year now.
 
  • Thread Starter Thread Starter
  • #5
Its for sale. $9,000.00 or BO and I might take yours in trade.
 
I'd like to get a newer one, but just can't swing it right now. I'm trying hard to get out of debt. About another year and I'll be there. Where are you located Jonsered?
 
Wanna whisper on trade? Would make it worth driving across the country.
 
Back
Top