Raj's latest activity

  • Raj
    Raj reacted to Dave Shepard's post in the thread milling thread with Like Like.
    I wasn't sure if this should go in milling or timber framing, so I'll put the timbers here, and the finished project in timber framing...
  • Raj
    Raj reacted to Dave Shepard's post in the thread milling thread with Like Like.
    Sawing some stuff for a new home build. An arborist who wants to feature a variety of locally salvaged materials. A nice but short butt...
  • Raj
    Raj reacted to Dave Shepard's post in the thread milling thread with Like Like.
    I just scored these three sycamore logs. Now I just have to get them home. And figure out how to quarter them. The one on top is the...
  • Raj
    Raj reacted to SeanKroll's post in the thread milling thread with Like Like.
    This was the only deadwood of significance in the part of the oak over the propane tank. It was still solidly attached. An old break...
  • Raj
    Raj reacted to Burnham's post in the thread milling thread with Like Like.
    Nice log! Even with the metal :).
  • Raj
    Raj reacted to Patrick A's post in the thread milling thread with Like Like.
    Chainsaw milling some white oak. The wind was in my favour so only half a PIA.
  • Raj
    Raj reacted to Dave Shepard's post in the thread milling thread with Like Like.
    I was able to get a "small" milling job done today. I'll link my Instagram post below. Quite a process to salvage this chunk of ash.
  • Raj
    Raj replied to the thread milling thread.
    https://www.facebook.com/share/r/mwiLqR5MhJn4qvxp/?mibextid=0VwfS7
  • Raj
    Raj replied to the thread milling thread.
    That was the customer that painted the logs.
  • Raj
    Raj replied to the thread milling thread.
    Finally got a milling job. Walnut in West Montrose.
    • 20240306_114311.jpg
  • Raj
    Raj reacted to stig's post in the thread milling thread with Like Like.
    We slabbed a large Ash burl for table tops today. Got 10 nice slabs.
  • Raj
    Raj reacted to stig's post in the thread milling thread with Like Like.
    We used 2 pieces of wood set at 90 degrees with a sharpened nail set at 4" to scribe a line to cut along, touched that up with a blue...
Show older items
Back
Top