whats this worth?

[thattreeguy]

2001 vermeer 9 inch...935?
perkins 35 hp diesel
1200 hrs
single feed wheel, pre bump bar era
former united rentals unit
jacknifed into curb in reverse:cry::
damaged spindle on lt side
and ring that holds chute on to housing (swivel point)
new knives, decent anvil,
hasnt been run in 3 months
$3000.00
spindle is generic...vermeer brand is $340.00, generic?
everything else appears ok
is it worth it?:?
i figured most ok machines are usually 3 to 5 grand to start

he'll take it in 2 payments as well...bonus

[NeTree]

SNAG THAT SHIT

[Skwerl]

They are a decent trim chipper but no comparison to a 12" unit. I've run a couple rental units and I think it should be worth $3K or close to it. If you can match up a generic hydro motor then that's the way to go. Vermeer gets top dollar for putting that yellow paint on generic parts.

[Stumper]

I think it is worth it.......but I know a guy who bought one running with okay spindles for $2100. ( Makes you wish you could have been there doesn't it?)

[thattreeguy]

round here there's nothing available you have to go to medford or san fran so 3 g seemed ok to me,xept i wolda loved 1 for 2100..wow

[stehansen]

Sounds good to me.

[thattreeguy]

i just saw a few online, darn things are selling for close to 9 grand, i think it'll be mine soon

[lumberjack]

I rented a 935 before I bought my 200+. I thought they had 50hp?

[Stumper]

Standard is a 35 hp.But I believe that they they did make some 50 hp 935s. (BTW 935...9 inch capacity/35 hp.)

[thattreeguy]

ahh thanks stumper,
ive never personally owned vermeer equipment, but ive run the hell out of 1800's
i have to check if its 50 hp, i thought it was 35
wouldnt that be a bonus!!
thanks y'all, wife actually supports me in it now

[Skwerl]

I think that Deutz diesel is a 42hp, but I may be wrong. The gas motor for that chipper is a 35hp.